Commercial Security -- Glass Break

Glass Break Sensors

2500
Dual Technology Glassbreak Detector

Ademco's patented processing circuit relies on the two disturbances always present during a glassbreak event; audible sound waves (3-5 KHz) and shock waves (200Hz) transmitted through a solid medium.

Senses audio and shock at the same time 2500 PIR
25' range from glass
UL listed for all types of glass protection
SMD (surface mount device) circuit design for better RF immunity
SPDT relay output for open or closed circuit activation
Alarm LED is latching or momentary
No test mode jumpers to move

2500 Specifications:

*Types of Glass*	Ordinary plate, tempered, wired plate, laminated Note: The No. 2500 is NOT recommended for protection of glass areas of less than 1/4 sq. ft
*Detection Method*	Simultaneous shock and sound
*Preferred Location*	On same wall as glass
*Alternative Location*	On wall touching glass's wall
*Along-Wall Range*	Within 25' of farthest protected glass
*Indicators*	SOUND (yellow) LED SHOCK (green) LED ALARM (red) LED
*Alarm Memory*	Latching ALARM LED (internally selectable)
*Input Voltage*	12 VDC nominal (10-16VDC, 3 V P-P ripple max.)
*Current Drain*	30mA
*Standby Capability*	Power source should be capable of 4 hrs (minimum) battery standby
*Alarm Relay Contacts*	SPDT, 1A max. at 24VDC
*Tamper Switch Output*	SPST contacts, closed with cover in place. Separate terminals for connection to 24hr loop, if desired
*Operating Temperature*	32 to 122º F (0 to 50º C)
*Operating Humidity*	Up to 95% RH (max.) non-condensing
*Dimensions*	2¹/16" W x 4¹/16" H x 11/16"D 52mm x 103mm x 18mm